Thank you all, for all the nice comments. I really appreciate it. I enjoy doing this kind of stuff and it's nice to be able to share it
with others who have the same interests.
Shryp - yes it is the same power with the electric controls and stainless. After I swap engines and get the electric all hooked up I'll post some photos.
I wanted the battery on board so I can run a larger watt light(s). Nothing that will burn the paint of things. Probably a 30W Halogen.
Also with the battery on board I can remove the current battery that is running the chute and deflector motors.
At some point I'm going to take off the double belt pulley and put on two single pulleys. The drive pulley will remain the
same size. But I'm going to put on a 1/2" larger impeller drive pulley. I have that pulley already. Just need to get a 2 1/2"
with a 1" bore pulley for the drive. If my math is correct that should give about a 200 rpm increase at the shaft. And a impeller
tip velocity increase of about 730 ft/s. That is one of the reasons I wanted to use an 11Hp and line the impeller housing with stainless.
Here are a few photos of the belt cover that I had to modify because the center of the crank (as you know) is higher on the clones.
I used a material called
Sintra it's really easy to work with. It's also formable when you put heat to it.
we'll see if it holds up. If it doesn't I guess I will use it as a pattern and see if I can make the cover out of thin aluminum.
I was fortunate to have to have a old blower without the blower. To do most of the measuring and fitting for the engine swap.
That is what the engine is sitting on. Now I know exactly what I have to do to my 1032 to make the swap.
Another project I'm thinking about (there is always another project) is mounting a 3" blade to the front of my spare drive unit.
You can see in the photos the rear piece of steel that I cut out of the back of the impeller housing from and out wasted blower housing.
That is what I will beef-up and mount the plow blade to.
What I really want and have been looking for, for about a year is one of the Ariens Broom attachments.
That is why I've hung on the the drive unit I have. I have actually found, just the other day in my price range.
But unfortunately it's 330 miles away, pick up only. Oh well, I really don't have the money to spend right now anyway.
Almost forgot,
chefwong I'm a 3rd generation finish carpenter. So, same processes different materials and tools.
Measure, cut, fit, assemble.
Also my mom sent me to summer school when I was about 11 or 12. It was a class in small engine basics and repair
Thanks Mom !!
(She probably just wanted to get me out of the house and know where I was.)
