Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Anyone want to clue me on a tip or two
I recently just regreased the auger on my HS724. Nothing complicated nor special...

I just fired it up for the 1st time since doing that.
It spun the Augers 1 1/2 rotation before it quit out on me.

I've been messing with it since, and it makes this loud creaking noise when I engage the auger and then the engine just quits on me....

It spun fine before I got it. Auger does not appear seized....

Pulled the top cover off. Belts look fine.
Fired her up .Engine is nice and smooth.
Yeap, confirmed it's the pulley.
Has the throttle in fast, engaged auger and she's smoking up as the belt is moving but not the pulley....and there is the source of my creak..
Now, on to the fix. Thoughts, suggestions.

chefwong wrote:


You're probably right, I got impatient and put on the coats too quickly and thick which did not allow it to properly cure. 

Going to strip it down and try again next spring.

FACEPALM

I bought a new bearing, replaced it, engaged auger drive and it spun.
Proceeded to button things back up. Put a couple bolts on the chassis to bucket, installed the auger and then I realized what I had done wrong.
I probably snugged the main bolt/washer that is on the sides of the bucket that turns out.....the washer sits ontop of the auger bearings and I probably snugged that way TOO tight when I installed the auger previously.

I'm thinking this was the issue, or maybe it was this and a bad impeller bearing, but all is well and she spins fine now.

Good, at least you found out what went wrong.  I wouldn't be happy putting things back without knowing the cause of the problem.

So now you know WHAT NOT TO DO when you remove your augers to grease them

Just in time for the snow.  Now put everything back before you break more stuff.  :)