Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Old Toro 7/24 - replacing the impeller bearing

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
Saddles


Joined: Feb 1, 2009
Points: 5

Old Toro 7/24 - replacing the impeller bearing
Original Message   Dec 4, 2010 8:58 pm
I am having difficulty accessing the impeller bearing of an old Toro 7/24 snowblower (serial number 38050).  I cracked the machine into two sections and removed the pully from the impeller, to expose the end of the impeller shaft (please link to the below photo). As seen in the photo, there is a small, long, rectangular piece of metal stuck to the shaft. I would like to slide the old impeller bearing off of the shaft, but can't because of this small, long, rectangular piece of metal. Any advice from someone who has dealt with this type of problem before would be really appreciated.

http://www.flickr.com/photos/56659718@N07/5233026762/


Replies: 1 - 5 of 5View as Thread
Replies: 1 - 5 of 5View as Thread
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.
Site by Take 42