Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Should I paint the wheel Axle - Honda HS

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
chefwong


Joined: Dec 18, 2004
Points: 175

Should I paint the wheel Axle - Honda HS
Original Message   Nov 10, 2010 9:02 pm
I plan to remove the wheel axle and sand/seal the rust off it it.

  • Am I better off sanding the rust, and then sealing it it, leaving it just bare steel sealed
  • Or painting the axle ...
That's the only rusty part on this slightly used machine, so I assume it's the most suspect part to rust...
Replies: 7 - 8 of 8Next page of topicsPreviousAllView as Outline
borat


Joined: Nov 10, 2007
Points: 2692

Re: Should I paint the wheel Axle - Honda HS
Reply #7   Nov 12, 2010 7:14 pm
I grease the length of axle that rides within the hub.  Beyond the hub to the chassis is painted with tremclad.  Grease annually. 
trouts2




Location: Marlboro MA
Joined: Dec 8, 2007
Points: 1328

Re: Should I paint the wheel Axle - Honda HS
Reply #8   Nov 12, 2010 7:44 pm
chefwong: Could you post a resized smaller picture that does not blow out the formatting of the thread?
Replies: 7 - 8 of 8Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.