Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I plan to remove the wheel axle and sand/seal the rust off it it.

• Am I better off sanding the rust, and then sealing it it, leaving it just bare steel sealed
• Or painting the axle ...

That's the only rusty part on this slightly used machine, so I assume it's the most suspect part to rust...

Weatherpruf sounds like an interesting product. From the web site:

"Weatherpruf 

Clear Rust Preventative - 1 Year Protection

Tough, clear weatherproof coating. A single coat provides 1 year of rust and corrosion protection in outdoor applications. Transparent coating will not harm metals, and may be applied over paint. Easily removed with mineral spirits, or may be painted over without additional preparations needed."

Do you find that you get more than the "1 year" of protection or do you re-apply annually? I might try it on my tablesaw that get left out in the garage over the winter.

I just normally reapply 1X a year. However, on a TS, will it be used during that time.
Since it's outdoor grade stuff, I just spay on heavy, brushback and let it dry. I don't go thin and brush smooth.
There are areas where it's *uneven* but it's a heavy coating it. Still transparent - kinda like if you were to spray heavy paint and not nice thin even coats.

For the tablesaw, I would just spritz and then brush it out for a light coat/layer. Unless if you don't intend to touch it, I'd go heavy coating. Mineral spirits will bring it back to bare metal.

 I went heavy so you can at least see what I mean by *uneven heavy* coating...
I fill the liquid in my spray can, spritz and just do a quick backbrush.
A light spritz with backbrush will generate a light even coat.

I went heavy....with a quick backbrush to level it off.
Hard to capture due to it being clear but hopefully u get the gist.

I grease the length of axle that rides within the hub.  Beyond the hub to the chassis is painted with tremclad.  Grease annually. 

chefwong: Could you post a resized smaller picture that does not blow out the formatting of the thread?