Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Craftsman Stalls When Clutch Released

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
catthepatch


Joined: May 30, 2010
Points: 4

Craftsman Stalls When Clutch Released
Original Message   May 30, 2010 12:16 am
Sears, Craftsman, 18Hp, 42" Mower, 5 Speed Transaxle
Model #944.605090
Engine Model #422707 Type #1529-01

Was running fine earlier.  Starts okay with clutch in but, when clutch is let out engine stalls.  Need to mow the lawn when the snow melts, ya it snowed here last night!  End of May?
Will be checking safety switch tomorrow, don't think that is the problem though, could be wrong.
Thanks in advance for any suggestions.
Replies: 3 - 4 of 4Next page of topicsPreviousAllView as Outline
JimmyM


Joined: Dec 20, 2009
Points: 82

Re: Craftsman Stalls When Clutch Released
Reply #3   Jun 1, 2010 8:14 am
Barring a lockup. I had a snow blower that would start and run fine until a load was placed on it. It would die almost immediately. The problem was a bunch a garbage in the bottom of the float bowl in the main jet. Once everything was cleaned out, it ran fine.
catthepatch


Joined: May 30, 2010
Points: 4

Re: Craftsman Stalls When Clutch Released
Reply #4   Jun 2, 2010 7:47 pm
Got it figured out today!  Quite a build up of junk at the Hydro pulley and a weak battery.  Now have to weld up the deck so the drive belt stays on.  Thanks for the support!  Later!!!
Replies: 3 - 4 of 4Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.