Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Using Stabil........

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
mikiewest


Joined: Dec 29, 2007
Points: 262

Using Stabil........
Original Message   Feb 1, 2010 5:56 pm
Is it o.k. to put any unused gas mixed w/stabil into an automobile ?
Replies: 2 - 4 of 4Next page of topicsPreviousAllView as Outline
borat


Joined: Nov 10, 2007
Points: 2692

Re: Using Stabil........
Reply #2   Feb 1, 2010 8:14 pm
Knee_Biter wrote:
Yes it is ok.  I always empty my year old gas into the truck.  I even use my old 2cycle in there as well.  Never had a problem.


Me too. Better to burn it than waste it. But don't dump five gallons of pre-mix into your vehicle. Small amounts will be so diluted that it will have no effect on anything.
This message was modified Feb 1, 2010 by borat
mikiewest


Joined: Dec 29, 2007
Points: 262

Re: Using Stabil........
Reply #3   Feb 1, 2010 8:23 pm
Thats good to know The "expert" at home depot told me not to.Well my 1st mistake was asking someone at that place for advice LOL.Some of the guys working there know their stuff.
oldcrow


If it ain't broke, try harder

Location: Northern MI
Joined: Jan 15, 2008
Points: 63

Re: Using Stabil........
Reply #4   Feb 14, 2010 1:45 pm
Yup - no sense in letting unused fuel go to waste. Sta-Bil works as advertised - I've been using it forever with excellent results.

I'd be careful about adding two-stroke mix to your car's tank, though. Sure, it will burn just fine - it's the commonly-used 5-micron fuel filter I'd be concerned about. If it's already dirty, even a little oil/paraffin/sludge can choke it off pretty quickly. Adding mix to the tank might present a good opportunity to change out your filter. GM vehicles, in particular, are known for burning out fuel pumps when the upstream pressure increases. Replacing the pump module is about 800 bucks (or more) at a dealership - versus 30 bucks for a new filter a couple of times each year.
Replies: 2 - 4 of 4Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.