Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Hard Starting Craftsman Rider

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
ramper


Joined: Dec 29, 2009
Points: 19

Hard Starting Craftsman Rider
Original Message   Jan 8, 2010 4:44 pm
Model number 917.257561 18 HP Twin Cylinder We seem to have to crank and crank. We changed the spark plugs and installed a new 300+ CCA Battery. We are unsure if we should choke it until it fires or not choke it and see what happens. We have it at WOT and choke it. Once it is going it seems to run fine. Should we try an "add to gas" engine cleaner (Gumout Seafoam, etc.)? On a side note: We are looking for ways to add weight to the rear to balance out a front snowblower. THANKS
Replies: 9 - 9 of 9Next page of topicsPreviousAllView as Outline
ramper


Joined: Dec 29, 2009
Points: 19

Re: Hard Starting Craftsman Rider
Reply #9   Jan 31, 2010 10:17 pm
I did add oil and it did start eventually. The tractor was on level ground. The synthetic "seemed" to make the tractor start better on cold mornings.
Replies: 9 - 9 of 9Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.