Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hey guys hoping someone can help me out with a starter issue.
I own an Ariens 1336PRO ST1336DLE Model# 924506 SN# 003716.
This model has the 12v battery electric start. I have owned it for 6 years and when I went to start it it just clicked like the battery was dead.
So I assumed after 6 years it was time to replace the battery. I purchased a new battery with a 340 CCA model that the manual suggested.
I made sure the terminals were clean but when I turned the key it still clicked and didn't turn over.
I assumed I was sold a dead battery but I tried the electric chute control and it moves fast like it has plenty of power.
I hooked up my battery charger and it said the battery was fully charged. I pulled out the multi meter and it is reading 13v.
There is no corrosion at all on the battery terminals and a little on the heavy gauge power wire that goes to the starter so I cleaned that connection.
When I test for power with the key turned to start there is no power on the heavy red wire that is connected to the starter. I assume there should be.

Do these starters have a remote Solenoid like a Ford or is it attached to the starter like a Chevy?
Is the solenoid located in the box under the battery? I think that is where the click comes from.
Does it sound like my issue is the starter solenoid?

I am aware I can still use the pull start but I have been spoiled for years with the electric so its worth it for me to fix it.

Thanks,
Ray

Seems like your voltage source is ok.  On 120v system it's common for the arm that comes out with the gear on it to mesh with the flywheel gears is rusted or has dried out grease.  They can usually be freed up with a screwdriiver and a little of lght oil. 

trout!!!!! tell me more about the 120 volt starter hanging up.is it because of the shaft and gear getting stuck or the flywheel ?i have only had trouble once with the 120 volt starter and that was the bolts that hold it in place came loose and stripped the hole threads.is there maintenance i should be doing to the starter? mike janesville wi.