Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

hi all! i picked up this snow blower from craigslist for 75 bucks..it runs well and everything seems to work..can any one tell me how old it might be..i was told in heavy snow it will throw the auger belt and that it was relplaced but still happens..no snow so i have not had a chance to use it..i ran it on blocks and looked underneath and all seems good..but thats under no load..any tips or thoughts would be great. thank you

rob

These kinds of units do not change overnight, maybe you can find a diffrent model that is similar and read up on that, maybe the same unit with diffrent engine or width would have a diffrent model but basicly be the same machine...

Also after the model and type code on the motor is (I believe) the date code... If the motor is original it should give the year it was made/ sold (within a year)

Post all the numbers off the motor for us and we will see what we can do.... (starts out 143.746062 xxxxxx) then we may find out what year it was made...

Good Luck,

Friiy

living on long island we got about 2' of snow for me to try my 75 dollar snowblower. never having owned a snow blower it worked pretty well.  It started easily but seemed to run a little rough. I'm going to get a new sparkplug, but i'm thinking its a carb issue. i read somewhere that these carbs are a pain to clean. I just went and got this number off the motor 143 746 062 ser 4325d. i also noticed that there was a lot of oil on the frame from the crancase vent. i think its pretty old so some blowby might be expected, ichecked the oil and it was on the low side. any ideas, should i try to clean the carb, any tips on that would be helpful.

thanks, rob

turned out the carb was loose..tightened the screw and it runs mint!!  i'm never that lucky..that was great.  i noticed that there is a guide/ pin that looks like its supposed to keep the drive belt from popping off when there is no load on it. its held in place by a bolt that goes into the case of the motor..well thats striped..i'm thinking i'll have to get a helicoil kit to propery fix that..but its still owes me nothing..then i thought jb weld and try put get the bolt back in..we'll see