Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I have an old Ariens lawn tractor that I am trying to refurbish.  I need to get the steering wheel off so I can remove the cowling to get at some levers that are frozen.  Does anyone know how to get the steering wheel off?  There appears to be some pins holding it on the shaft.  Can I just knock them out with a nail set or something similar?  I am soaking them at present since there appears to be a lot of rust in there.  Thank you...

A roll pin is a hollow pin with a split down the side and has tapered ends (slight taper)... A roll pin is a little harder to drill out (hardened spring steal). When it is driven in, it compresses under spring tension, and locks in a little tighter..

Yes, you can drill them out, and punch them out. But you should wear goggles, they can be brittle like a drill bit and shatter at times..


.... or it could be a regular pin and you just drive it out... (solid pin).


Good luck.

Friiy

Is this one of those single blade, rear engine Ariens?