Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

My 2007 model has developed a leak in the fuel tank.  It seems to be a crack where the tank seam is.  Anyone else having the same problem?  This problem has cropped up before with Toro.  The engine is produced by Tecumseh and Toro says it is a Tecumseh problem.  Seems Tecumseh has sold their power engine division to a company called Certified Parts.  All I get is the runaround from both companies.  The fuel tank is on back-order which leads me to think that others are having the same problem.  The mower has been sitting in the repair shop since mid-May and it is going nowhere fast.

I recommend any others with the same problem to start contacting Toro to get them off their butts.  Also, contact the Consumer Products Safety Commission to report the problem.  A recall may be in order if this problem is wide spread.

Thanks Everyone

Mark.
Tanks splitting on Tecumseh LV195EA engines isnt a common problem.
Briggs has had the seam splitting problem for the last 20 years and at one time did a have recall and continue too replace tanks under warranty.
With your machine being a 2007 model (2 years old) neither Toro or Tecumseh should have a problem replacing the tank.......If they can get one.
There is not much anybody can do if the tank is on back order.
Dealer distributors have been pretty good about filling Tecumseh parts orders on the commonly used parts. Less commonly ordered parts (like fuel tanks) may be harder too get.
There should be plenty of those tanks (37947) in the junkyards. If you need the machine, that might be an alternative?
 

Back in 1990 or so.... Briggs had a recall with 5 hp Quantum fuel tanks with a leaky fuel valve....

All were recalled, one out of 4 was made with plastic valve mounting area too thin due to a batch of bad tank molds.. It cost Briggs XXX milions to recall and pay dealer to replace them.... I use to keep the extra stickers that came with the tanks (I had two inches of stickers after 1 year)....


Friiy

If a replacement tank will not be readily available, why not fix the defective unit? I'd report the problem to the dealer, have them order a replacement tank if available then try to repair the old one. If the old one can be permanently repaired, job done. If not, I'd jury rig something that would do the job rather than wait for ever for something that might never arrive.

Tecumseh has been out of business for over 5 years now.

I just developed the same problem. I did find the part available online (almost 30$ when you include shipping and taxes!). I did a quick patch using a fuel patch epoxy / fiberglass cloth (10$) from local auto parts. Still leaking a little bit, so glad the part has been ordered. Looking for a diagram showing how the motor is assembled so I can refer to it when I am installing the new part. Did not chase the warranty. I don't have the time to spend on that rabbit chase.

I have had this happen to TWO tanks on the same mower now.  Frankly I think this gas tank is a pretty crappy design.  I mean really, how hard is it to make a one piece gas tank for this size mower??  My first tank ruptured within two months of purchase and was replaced under warranty and now it's happened again in less then two years.  I emailed Toro about the situation and they completely blew me off.  I have to believe that this is not an uncommon problem with this model yet they refuse to even discuss the issue.  Pretty lousy customer support if you ask me.

I have a Toro 22 inch mower with the same problem.  It developed shortly after I purchased the mower.  I contacted Toro, but got no response from them.  The leak appears to be around the tank seam, so I filled the mower only part way to avoid having the gas reach the seam.  This worked while the leak was minimal, but the seam continues to get worse.  I may try to patch the tank somehow; it appears that I have not been the only person with the problem; nor the only person that Toro has ignored.  I will not purchase another Toro product.

I would  be willing to join a class action against Toro if this problem is widespread.

I have a Toro 22 inch mower with the same problem.  It developed shortly after I purchased the mower.  I contacted Toro, but got no response from them.  The leak appears to be around the tank seam, so I filled the mower only part way to avoid having the gas reach the seam.  This worked while the leak was minimal, but the seam continues to get worse.  I may try to patch the tank somehow; it appears that I have not been the only person with the problem; nor the only person that Toro has ignored.  I will not purchase another Toro product.

I would  be willing to join a class action against Toro if this problem is widespread.

My 2007 model also developed a leak around the tank seam.  I ordered another and replaced and now less than a year later, the second tank has developed the same crack around the tank seam.  Conveniently, Toro claims ignorance on the issue and says to contact a local service provider.  I contacted one here in Austin, TX and was told the tanks are on back order and that they had 50 something request for the tanks. 

You can try to repair the tank using JB Weld. 

Take the tank off, drain all the fuel from it.  Try to pry open the leaking area of the seam and put some JB Weld in the crack.

 If that's not possible, you can try heating the seam with a soldering tool  or open flame to plastic weld it together.   Be very careful of the possibility of gasoline vapour ignition.  Probably best to purge the tank with hot water and allow it to dry before introducing open flame to it. 

This stuff works great on metals, I give away alot of NOS stuff like this to friends with problems....  I do not know if it works on Plastic.. . They also make a paint brush consistancy  mix.

http://www.bergdahl.com/PS-860.htm

Friiy

I have the same model  lawn mower with a fuel tank leak as well.  I contacted Toro's customer service (1-888-384-9939) and was told that they are not aware of any widespread problem with a leaking fuel tank for this model and no recalls have been made.  I was told to stop using the lawn mower immediately and get it to an authorized Toro dealer.  I contacted the dealer, it is going to cost about $28.00 for the part (including shipping, they do not keep it in stock) and $28.00 for labor.  I went ahead and ordered the part from the dealer because I need to get it fixed.  I was told it should only be about a day  before the part comes in. However, before getting off the line with the Toro customer service representative I asked her to provide me a case number and send me an email confirming my complaint in the event this is picked up as a class action lawsuit.

I have this issue with my Toro #20073 Recycler 3 & 1  mower and I called the company (Certified Parts Corp) that took over for Tecumseh when they went out of business. They referred me to an EMail address that you can contact to get a free replacement gas tank. You have to take pictures of the engine ID decal and EMail to: tankshiper@gmail.com. The valid Date of Mfg (DOM) range is 07001Gxxxxxxx to 07120Gxxxxxx. I have not reciev4ed the new one yet but have received confirmation of receipt.

Excerpt from acknowledgment:

Thank you for your request. Please submit the required information as specified in Service Bulletin # 506. After we recieve the required information, a new tank will be mailed to you via first class mail.

Thank You.

CBD Services LLC

tankshiper or tankshipper?

I don't have one, but seems like a typo in the email :)

For people that are looking for one, any way to zip tie some other tank to the handlebars for the time being?

I purchased my Toro 22 inch recycler lawn mower in April of 2007.  The fuel tank last week started to leak at the seal too.  The Model number is 20071 and serial no. 270098455.   Does anyone know how I can get Toro to fix this issue?  Thanks for any info.

5 years later?...  I think it's out of warranty.  Just contact toro, they will let you know who made the engine and if it is still under warranty.

--

I have a Toro 20073 with a fuel tank leak at the seam and I followed RDGUS's instructions (see below). I just got a new fuel tank in the mail today!!!! Totally free with free shipping!!!!! It took less than a week to receive it. I'm doing a happy dance right now :-). Now, I just have to figure out how to take off the old one and install the new one. Wish me luck! rdgus wrote:

Sent email as describe in earlier message and auto response returned in seconds..............Note the correct email address is tankshiper@gmail.com

Tank Claim Re: Toro 20071