Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hello my friends,
now that the nice weather is upon us, I am gearing up to "hibernate" my Ariens 927LE for the summer...
The gas tank is still almost full but I had added Motomaster concentrated small engine tune up, from Canadian Tire, so is this enough? Or should I just run the engine dry? I don't have access to Seafoam so is there anything else I should use?
What else should I look for? I already popped off the wheels and greased the axles, but I haven't done anything to the cables, impeller, belts, etc... I have White lithium grease as well as regular 3-in-1 oil, and WD40...Are these ok?
Any advice for a noob? I didn't pay $1000 to have a machine that's going to last me 2-3 years...
Thanks guys and gals...

Every freakin year I tell myself I'm going to put a Tee in the gas line so I can drain the tank. Every year I forget to go get the parts :(  It's like a 15 minute job and only costs a few bucks. This weekend I (once again) ended up holding a glass jar under the carb and holding in the drain button and getting out 1/4 tank a few drips at a time. As much gas ran down my elbow as went into the jar.  Anyway, it's something you might want to consider. A T, a shutoff valve, some clamps, a short piece of tubing, and a carriage bolt that fits inside the tubing. Clamp that in because you don't want to trust that shutoff valve.

Personally, I don't trust WD-40 all that much, it evaporates too quickly for me. I use Brak-Free CLP instead, just cover everything that might rust with it. It collects a lot of dust over the summer but it all gets cleaned off the first time it gets used the next winter. I also spray it inside the cables. At one time I would wipe everything down with an oily rag, this is a lot easier and seems to work just as well.  Just don't get anything anywhere close to the belts or pulleys. Check the auger bearings and see if they can be lubed.

BTW, the manual should have a checklist of what you do to put it away for storage - I don't have an Ariens so I'm not sure if it does, never hurts to look, though.

Ok, thanks guys,
one more question (for now). In my manual it indicates that the service position when performing work on the machine is to tip it up on its' impeller housing. My question to you is whether or not I can leave it like that all summer or if I should just rig up some 2x4's to take the weight off the wheels and store it horizontally?Also, if i have some chipped paint scratches inside the discharge chute, should I sand them down and apply some paint or not worry about them?
Good suggestion about the "T" in the fuel line Bill, I think that'll be my next project...
thanks again for all the advice..