JohnDeere broke in half Original Message Mar 9, 2009 10:45 am
As the subject says.I was blowing snow this morning and the old Deere split in two.Is it connected by a bolt?I did not really look at it.This is not supposed to happen.Any info i get would be great.I can give more info about it later,thanks,Don
I've never tipped it on its side ( intentionally, but lets not talk about that ). Check the other side to see if there is a lower stud or bolt sticking out that the traction unit can latch onto. From what I can see the John Deere may use a different system since I do not see the "hook" is was expecting. I've had the nuts that the upper bolts screw into come off but not the lower pivots. There is what looks like a tear mark on the auger housing and there is a metal finger stickning out from the traction unist si it could be that the pivot has been torn out. If so then it might be a good idea to reinforce the area before putting in a new rod to act as a pivot. Getting a welder is starting to look nicer and nicer .
Re: JohnDeere broke in half Reply #9 Mar 15, 2009 2:59 pm
She is runnin again.When i split it apart,there where 2 pieces that the weld broke.Re welded and bam back in action.Hope to try it out next season.I'm sick of snow.Thanks for your help.Don
). Check the other side to see if there is a lower stud or bolt sticking out that the traction unit can latch onto. From what I can see the John Deere may use a different system since I do not see the "hook" is was expecting. I've had the nuts that the upper bolts screw into come off but not the lower pivots. There is what looks like a tear mark on the auger housing and there is a metal finger stickning out from the traction unist si it could be that the pivot has been torn out. If so then it might be a good idea to reinforce the area before putting in a new rod to act as a pivot. Getting a welder is starting to look nicer and nicer 
.