JohnDeere broke in half Original Message Mar 9, 2009 10:45 am
As the subject says.I was blowing snow this morning and the old Deere split in two.Is it connected by a bolt?I did not really look at it.This is not supposed to happen.Any info i get would be great.I can give more info about it later,thanks,Don
Re: JohnDeere broke in half Reply #6 Mar 13, 2009 5:36 pm
Hey Nibbler it isnt fixed yet.I am going to look at it toomorow.I know i will have a couple of questions,and i will put pics in the morning.From what i see so far,the welded bolt is not there anymore.Would it be easier to tip the machine on it's side?Thanks.Don
I've never tipped it on its side ( intentionally, but lets not talk about that ). Check the other side to see if there is a lower stud or bolt sticking out that the traction unit can latch onto. From what I can see the John Deere may use a different system since I do not see the "hook" is was expecting. I've had the nuts that the upper bolts screw into come off but not the lower pivots. There is what looks like a tear mark on the auger housing and there is a metal finger stickning out from the traction unist si it could be that the pivot has been torn out. If so then it might be a good idea to reinforce the area before putting in a new rod to act as a pivot. Getting a welder is starting to look nicer and nicer .
Re: JohnDeere broke in half Reply #9 Mar 15, 2009 2:59 pm
She is runnin again.When i split it apart,there where 2 pieces that the weld broke.Re welded and bam back in action.Hope to try it out next season.I'm sick of snow.Thanks for your help.Don
Here are a few pictures of where it came apart.
). Check the other side to see if there is a lower stud or bolt sticking out that the traction unit can latch onto. From what I can see the John Deere may use a different system since I do not see the "hook" is was expecting. I've had the nuts that the upper bolts screw into come off but not the lower pivots. There is what looks like a tear mark on the auger housing and there is a metal finger stickning out from the traction unist si it could be that the pivot has been torn out. If so then it might be a good idea to reinforce the area before putting in a new rod to act as a pivot. Getting a welder is starting to look nicer and nicer 
.