Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

My dad's Simplicity 724 with the Tecumseh H70 bit the dust on Saturday. 

I've looked at replacing the engine with a B&S, but it appears the B&S output shaft turns in the wrong direction (CCW),  and the pull starter would be facing the front of the machine.  

The H70 is a 7.0 hp, 3/4" output shaft on the left of the machine when you are in position.

Any ideas?

Thanks!

Chris may be speaking of the old Paddle wheel model 724. If you are standing in the operators position the output shaft is 90 degrees to the left instead of facing forward. The pull starter pulls towards the handle bars on the right . I'm not sure about the direction of rotation but I believe it's CCW. If you used a conventionally configured blower engine to repower the pull starter would be facing to the right side of the machine.Smalll Engine Warehouse has a 7hp ohv Tecumseh Snow engine with a 3/4 shaft  of the proper length  . The head will also tilt to the back and the muffler will face the back but may work. . The price I believe is $240.

 I am currently restoring a similar 524 which is the same frame  smaller engine.

Marc

Marc, all,

You are correct - it is a paddle wheel Simplicity 724 model with the H-70 motor.  I did confirm a CCW rotation of the shaft which is on the left side (in operator position).

My dad (87) just hates parting with his old stuff.  I have to admit - it's a beast of a machine.  It (H70) threw a rod, and that was after I repaired it 2 years ago.  Makes me believe there was something else wrong.

The replacement Tecumseh motor's pull starter would face front, but it wouldn't be a problem since I could pull the starter rope outwards past the machines handles.

I believe I would need a spacer block, as the H70's shaft height is higher than the replacement's  - 4.125".  I'm going to remove the motor on my next visit, and get the measurements.  I did see the snow motor on the http://smallenginewarehouse.com site for $240.  That will work, I believe.

Marc - One thing that might be a problem - the machine's belt guides are bolted to the H-70's motor area near the output shaft.   Is this going to work with the new motor?  What did you do?

Thanks - great forum!

Chris- The 524 I am working on has the original 5hp in working condition so no replacement is necessary. I don't know if the replacement Tec. OHV has the tapped holes for the belt guides. I would suggest you call SEW and ask. Most blower engines I have seen have a # of tapped bolt "receptacles " as it is pretty standard fare to have belt guides on most every machine.

I am curious as to what you mean when you say the starter faces forward. If you mean the direction you pull the rope is forward that is easily changed as was pointed out by Friiy in a previous post.  As he pointed out all you need do is rotate the pull starter assembly to a position favoring your installation.

Marc

Marc,

I can try to rotate the starter.  Looks like there are extra holes. 

Need to assess the bolt pattern for the guides.  The drawing doesn't specify spacing, just bolt size.

I will call SEW once I measure my old H-70's bolt pattern.

Thanks all,

Chris