Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Side-mount skid shoes on hs1132 - affect the ability to change auger height?

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
dfvellone


Joined: Jan 10, 2009
Points: 20

Side-mount skid shoes on hs1132 - affect the ability to change auger height?
Original Message   Feb 2, 2009 11:56 am
I just recently installed the side-mount skid shoes on my hs 1132.

 I might be wrong but it seems that maybe their more forward location changes the pivot point of the bucket, making the difference between mid and low adjustment less dramatic. Does anybody else with these shoes notice this? I am measuring a bit of a difference in auger clearance, but because the scraper is now behind the pivot point it doesn't seem to change height - maybe it never did since I didn't check it's movement with the rear-mount shoes before I removed them.

I can't otherwise really say what I think of the difference between the two shoes. I've only cleared a couple times since installing them and my driveway looks like the downhill moguls run right now.

They weren't that cheap though.

Any solid opinions on their performance?

 Why does Honda offer this option and why they rear-mount. I'd think they must have put some thought into that rear-mount design for some good reason- maybe the pivot point for adjustability?
Replies: 7 - 7 of 7Next page of topicsPreviousAllView as Outline
aa335


Joined: Nov 29, 2008
Points: 2434

Re: Side-mount skid shoes on hs1132 - affect the ability to change auger height?
Reply #7   Feb 5, 2009 2:54 pm
dfvellone wrote:
I drilled holes and used the plates. There isn't much room for error either - the shape of the bucket housing where the shoes get mounted restricts where you can mount them. I might have been able to mount them forward a bit, but probably not enough to make much of a difference.

Why do you have your scraper bar so high? New scraper?  I adjusted mine as per Honda's recommendation (3-5/32nds above grade at the mid setting) and that puts the bar at the bottom end of the slots.
 

Yes, the scraper bar is new, 2 and 3/8 inch wide .  My auger clearance to the pavement is 5/32 inch, scraper bar 1/16 inch.
Replies: 7 - 7 of 7Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.