Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Would appreciate suggestion.  Newbie to snow blowing.

My craftsman has started and ran great for the last year.  Today, only half of the auger ("passenger" side) turns  when engaged.  The impeller is still working.  With the engine off, the "passenger" side will rotate nearly one revolution freely, until hitting a stop, which I assume is the engine.  The "drivers" side freewheels.  How do I fix this?  We've got quite a load outside.  Many thanks.  I'll reply with the model # if I can find it.

looks like the impeller and shaft to the gear box are spinning...but the auger doesn't move.....so either this model (536.886190) has more than two shear bolts, or gear box broken I guess.

More than likely a gear box problem if your positively sure that the shaft to the gear box is turning. I took a look at a parts breakdown as per your model number stated and looks like your auger assembly is only a two part system not as Nibbler mentioned possibly a four part auger system.

Puck, in your original post you said that half of the augers turned, are you saying now that neither of them are turning or is it still just half of the augers?

Puck

If you depress the auger lever with the motor off ,spark plug wire disconected and tie something around the lever to keep it engaged (depressed) you then should not be able to rotate the augers by hand. .So if when you have it depressed and the impeller does not move and the augers still spin freely, both sides ,then you have  a gear box issue assuming you have shear bolts in place. If while depressed the impeller moves too then your problem lies in the area of belt and pulley .

clay,
Originally, the one side moved some, slowly.  Now, with the shear bolt replaced neither move.

If I engage the auger with the engine off, I can turn both augers , but the impeller does not turn, so I guess gear box.  I have both shear bolts in.

If you're lucky, there might be a locking pin that secures the drive gear to the drive shaft.  If it has sheared, you might just need to replace that.  So, pull it apart and tell us what you find.  Pay close attention to how it comes apart.  Watch for bushings, seals and washers.  Take some digital pics to aid in re-assembly.

puck1263 wrote:
Puck
Lets see some good pics of your problem before the fix.Best of luck,Allan.

Guys,
Not sure how to take a picture.  Any picture I take will look like a normal unit.  I think I found the cause of the damage, however.  It appears the previous owner used a regular bolt, not a shear bolt in the other half.

I took all the bolts out of the gear housing, thinking it would split in half so I can get to the gears, but it hasn't.  Any good ideas how to take it apart?

Puck,

Did you resolve the problem?  I have the exact same thing happening with my 3 month old Craftsman. One Augur spins freely (same side as yours).  I'm about to take it apart and i'm hoping it's as simple as a sheared locking pin.  Here's the link to my snowblower.

 http://www.sears.ca/gp/product/B001JHWG1O/sr=1-4/qid=1233242236/ref=sr_1_4/185-2559315-2707731?ie=UTF8&searsBrand=core&mqnodeid=394759011