Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I have an Ariens 1028 that just recently quit moving forward or reverse, although the auger still functions perfectly.  When you hold the left lever and have the unit in gear it actually acts as if you have the breaks on and if you don't hold the lever while in gear you can physical push the unit either forward or back.  The unit is far to bulky to not utilize a drive wheel; any suggestions?

Given the following symptoms:

1. You can push the unit when the traction clutch is disengaged and can't when it is engaged;
2. You didn't mention any noise or smoke when engaging the traction clutch..

I suspect:

1. The friction disk is working OK;
2. The engine is disconnected from the traction system and either the pulley on the engine shaft  is spinning freely or the belt is broken
3. The traction transmission is locked up between the friction disk and the traction pulley.
   

If the traction system was locked closer to the wheels then the traction clutch wouldn't have any affect. If the traction transmission isn't locked up then there is enough friction in the system to stop you from pushing the unit even though the engine is disconnected due to item 2 just above.

bbwb wrote:
I don't need them, but your pictures in that thread are gone.

Paul