Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Drive belt wear

Any ideas what could be causing the drive belt wear seen in following pictures?

http://picasaweb.google.com/audreyappliance/WornDriveBelt?authkey=TpuWljxHp0o&feat=directlink

Sorry some pics blurry. I also pulled belt off to side of pulley so you could see some of the wear.

I did have some slow speed engagement problems earlier that I was able to address by adjusting the drive control rod. It seems there was too much slack. I haven't had any engagement issues since and I suppose this wear could've occurred before the adjustment of drive control rod.

One theory I have is that clearance of the traction drive pulley in regards to the friction drive might be too far apart and causing this wear. If drive pulley is pulled closer to wheel the belt wear may be mitigated on that one side of belt. Visually looking down at drive pulley I see belt rides that one side of pulley in the drive disengaged mode. In drive engaged mode it appears they line up correctly. This blower doesn't have any belt adjustments. They tell you to just replace the belts when they are worn or broken.

Service manual says the following on clearance:

"the disengaged position adjust the clearance between the Rubber Wheel Ring and the Drive Plate Assembly to .125"-.140". "

This is adjusted from from where the control rod attaches to lower left side of rear frame body by a spring. There is a nut that can be adjusted on the clutch rod.

I usually only plow in lowest gear and don't really push it. Auger belt is perfect. I intend to monitor the wear to see if it gets worse or stays in holding patter. I do have spare belts. It seems only about half of the belt has this wear so at some point there was some slipping that occurred on about half of it. The other half on that side is in good condition.

Drive engagement works perfect too.

Thoughts? Let me know if I need to clarify anything.

Thanks!
Snowmachine

I may need to do that trick with the foot powder if nothing else turns up a clear solution... hopefully like Borat suggested I may have solved my problem with disassembly/reassembly. Time will tell. I had her tear into some compact snow and ice today. It seemed to slice through it pretty easily.



Clay wrote:

If you try the foot powder thing, incorporate Borats idea of lifting the wheels off of the ground.  A floor jack would be perfect, but there are many ways to suspend the wheels off of the ground from a piece of firewood that you have handy to a concrete block.  That way you won't have to walk around after it and you can isolate that probablem easier.  If you do it inside of your garage, make sure that you have enough ventilation while running that engine.  What is nice is that access to those two belts are a matter of just undoing two bolts and pulling the cover.  I'll keep watching this one.

Rick