Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I believe the HS621 was sold last sold in the US a few years ago.  Now it is only available in Canada.  I can't find this model new anywhere in the US.  The available current model is a HS520 which is smaller and have an overhead cam engine versus the superior OHV engine on the HS621?  The build quality also seemed to be cheapened on the HS520 as well.

On a different topic but somewhat related to Honda, I'm trying to understand why the model line up for the US market is so watered down compared what is available in Canada?  Canadian two stage models have even have hydraulic assist auger height adjustment, electric chute, as well as onboard 12V battery starter.  I know I am a minority when it comes to having these gizmos on a snowblower so bear with me.  If any of you have seen what is available from Yamaha in Japan, some folks may conclude that snowblowers available in the US are very primitive in comparison.   Does the US market not demand these features and technology?

mml4 wrote:

In some cases, you might be right.  However, the Honda GC series are the aluminum bore engines and less robust than the GX series.  If you buy a GX series OHC engine, it's as rugged as any other GX engine regardless of valve configuration.  I have a Honda GX series OHC  V-twin engine in my yard tractor.  The distinction is not whether it's OHC.  It whether it's a GX or a GC.  By the way, the B&S snow engines are all aluminum bore engines similar to the GC series.  Would they be considered as throw away also?

Borat

1)Check the SEW web site-Many Briggs Snow engines have a cast Iron bore.

2)I am sure the GX ohc engines are fine but the GC engines used on mowers and pressure washers have proven to be less than stellar having to do with the valve train.

 3)I didn't mention anything about Aluminum Bores being the basis for  throw aways on Hondas or Briggs or anything else so I am confused by your question.

However I do know that the special order Briggs used by Simplicity and Snapper on their blowers in 2005 were all aluminum bore engines badged as 9.5hp-12hp. They are fine units (my son has one in a Simplicity 1060DLXE) but you couldn't buy one from the  Briggs catalog. I am not sure about the later units as I haven't kept up.Perhaps you can enlighten us-

Marc

Tmml4 wrote:

!)  I said the B&S Snow engines have an aluminum bore.  I didn't mention any other B&S engines, of which, I'm fairly familiar with.  As far as I know, all of their Snow engines are aluminum bore.  They make a Snow Intek engine with a cast iron bore, but that's not the same as their Snow or Snow Max engines which are offered on all snow throwers using B&S overhead valve engines.  I've yet to see a Snow Intek on any available snow thrower presently on the market.  That's what  I'm referring to.   You can correct me if  I'm  wrong. 

2) I made the distinction that the GX engine regardless of valve configuration is superior to the GC series engines.  I'm not defending GC engines.  You had previously stated that the Honda OHC engines were inferior.

3) Aluminum bore is one of the major differences  (if not THE major difference) between a GC and a GX engine.   Considering the B&S snow series engines are aluminum bore as well, would they be classed as a throw away engine as you say the Honda GC is?