Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hi Fred-
I would like to install the swing ball valve on my machine..Where would you get a Swing ball valve of the proper size?

Is it made of brass? Is it already set up for the wire safety or do you need to drill a hole in the handle? Is it possible to post a picture of your installation?

Thanks for the great idea,

Marc

Yes Fred, Please. I think they are a great reference for drift cutters. skids, and quick oil change valves. I have another question. I'll send a PM.

robmints@qis.net

Hi guys!

Thanks for the pictures! Does the valve come in a 90 degree configuration or do you use an elbow?

The idea of being able to route the oil through a tube into a container instead of all the mess associated with an oil change is terrific!!!!!!

Thanks again,

Marc

I have never seen one that I remember. McMaster has alot of stuff. Just so you can see what is available.

         Rob,

       Emailed the photos, if you want more, let me know.

                                             Fred    

   Rob,

      Thanks for posting the photo!

                                          Fred        

Fred,
Thanks for making the pictures available. I think they will be a great help to people as questions come up.

Great idea!  

Could someone please post the thread size of the cap nut on the typical Ariens engine(s)

Its just a standard ball valve that you can get from most hardware stores. You'll probably need a 1" long nipple to go between the drain hole in engine and the valve.  There are several configurations available. I got one set up that uses a braided stainless steel hose on it and an end cap. The hose is normally used to connect water pipes to fixtures such as toilets and fawcets. There's all sorts of stuff in the plumbing section. If I remember correctly the hole is 3/8" NPT ( National Pipe Thread)