Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Our generator lasted valiantly for most of the week without power, until the starter rope stopped turning the engine over.  In other words, it pulls easily and retracts properly, but without the stiff resistance from actually moving the crankshaft.  It's intermittent, so I gather it's something in the ratcheting mechanism that's sticking.  To make things more complicated, the cover of the recoil mechanism is riveted to the engine, so I don't think it's something I could easily remove and replace.

Any suggestions, short of having our local small engine shop pick it up and fix it?  Or what it might cost if they do?  That's assuming they will.  They don't normally stock generators, but I presume that there isn't a huge difference between the B&S engines that power this versus other products.  (I think we got it via the electrician who installed our transfer panel, but I've no idea who his supplier was, and that was ten years ago.)

Fortunately power is finally back, but not before I picked up a 5KW Husky generator from Home Depot as a backup measure.  I still haven't opened it yet, and we'll need to decide whether to keep it or fix the Generac.  Opinions on this decision are also welcome.

Many thanks,

Gary

That Clutch assy. has five or so steal bearings in it...  The bearings catch in the assy when you pull the starter and  the bearings jam in the mech ..When the engine is running the bearings are forced  out of the way and allows the engine rewind to ratchet freely..    When the starter  unit  "does not Catch",  the bearings have stuck in the postion of the engine running ( gummy grease inside the starter ratchet).

If it was me I would change the ratchet assy,  It unscrews Like a nut,   put a 2X4 against the large cast ears on it and give it a good wack counter clock-wise...  Last time I bought one it was about $14..

You can take off the cap that is held on by 2 screws and lube it with  wd-40,  but the little square part that rides on the end of the crank has a light oil inbeded in it...  if it gets gummy and drys out-- it can ruin the rewind assy, spring, pully, adn crank end... (you can tell when that is going bad... the engine makes a squeal).

When you go to replace the ratchet,  be sure to clean all the varnish and gummy grease off of the crank end that goes in the square part of the ratchet assy..,  this will extend its life...

Friiy