Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

HELP!!!!!

I just replaced  the friction wheel on the Ariens 824 Snow thrower.  Everything appears to be working fine including the reverse which seems to be working great.  However when I put it in forward, nothing happens.   When I engage the gears in forward the friction disc just stops.  All seem to move free until I try to go forward. Anybody have any clue??? 

Snowman - How do you "pop off" the bottom to check the friction disk.  My Ariens 824 stutters as it goes forward and anything it runs into it just stops, the wheels don't spin like it used to.  I basically push the thing and every once in a while it will engage.  From everything I have read the friction disk seems like the culprit.  I can follow instructions well I just can't find any to do this job.  Can you assist or even point me to a How-To guide?

My back will thank you.

I just posted in the other post about the st824 and the augers not turning. In there, I posted links to what I believe is the service, parts and owner manuals for this machine. It should tell you how to replace friction disc.  AS for remove the pan, tip the unit in service position ( standing up on its bucket) and then should be bolts holding the pan on the bottom. Remove them, look in at the guts. :)  Before putting in service position, I like to shut off fuel valve and run machine dry. I make sure the fuel and oil cap and tight.


Without having the exact model and serial, I believe the below may be your parts manual.

http://apache.ariens.com/manuals/PM-24-89.pdf

This is your service manual.

http://apache.ariens.com/manuals/000123A.pdf

And owners manual

http://apache.ariens.com/manuals/024532.pdf

Thanks for the fast response.  I appreciate it.

The spring has come off, which should attach to the drive belt idler arm. I see the hole in the arm where one end of the spring attaches, but can't find the place to attach the other end of the spring. Can anyone help?
Thanks