Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Snow thrower cab
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
aa335
Joined: Nov 29, 2008
Points: 2434
|
|
Re: Snow thrower cab
Reply #19 Dec 24, 2008 12:03 am |
|
Last year I posted a similar comment on a different (the OPE ) forum. I couldn't believe the number of replies that said snow cabs look goofy, made the operator look like a dork or was just not cool? All these years of snow throwing, I had missed the part about how one should look while doing it. Got to wonder what goes through some people's heads some times. Personally, I think looking warm is a far better experience.
I wear glasses so stopping every few minutes to wipe off the wet snow has become a real pain. I was constantly adjusting the chute direction and deflector angle to minimize the snow blowing back in my face. I thought about using ski goggles over my glasses but I read on the forum that some people have problem with the goggles fogging up. Also, even with the goggles, my face is not completely protected from the blowing snow. I decided to get the snow cab and give it a try. I have to admit that after seeing on youtube.com a guy using a snowblower with a snow cab and it did look goofy. From the side, it looked like a John Deere tractor but instead of the two large tires in the rear, there are these two small legs moving in the back. :) I did have a good laugh or two watching that video. I was able to find the Classic Accessories Deluxe Snow Cab at Blain's Farm and Fleet for $94. Everywhere else online was charging $129. Stock status was getting depleted at most online places and I didn't want to wait for shipping when the Midwest is about to be pummeled with snow for the next two weeks. Anyways, if you go online to Farm and Fleet website, you can check stock status of a local store. I found a store nearby that had it in stock, and immediately called the store to verify stock status placed it on hold until I can pick it up later in the evening. I installed the snow cab and the process took around 2.5 hours. I was done in 1.5 hours but took another hour to tweak and fine tune the fit to my liking. Got out my carpenter's level and make sure everything was level and plumb. I also adjusted the height so that it's not too high and unstable in the wind, but not too low that the canopy would come down and wack me in the head when the snowblower decided to climb a snow bank. It was all good to my satisfaction. Tried it out the next evening. Wow! What a difference it made when its 0 degrees outside with 15 mph head wind. I was well protected from the blasting wind and snow. I actually felt a lot warmer tucked behind the cab. I can blow the snow higher and further without worrying about it flying back at my face. I was a self conscious about the neighbors watching and thinking how goofy or silly I look in the snow cab. But that didn't matter for long, I was protected and enjoying snowblowing. This is the only negatives I have of the snow cab. They are minor but I will mention them. I did try removing the canopy top and putting back on. Removing it was easy, pull two pins and lift the canopy straight up. Putting it back on was not so easy unless you had someone holding the other side for you. Also, it was a little work trying to get the four holes on each side of the pipes to line up so I can reinsert the pins. I don't think I will be taking off the canopy very often so this is not an issue. Also, the pins do vibrate and make a noise like something on the a snowblower was coming apart under the vibration of the engine. However, I just rotate the pin until the vibration stopped. Well, that's my story and I'm glad I bought the snow cab.
|
Bill_H
Location: Maine
Joined: Jan 12, 2008
Points: 354
|
|
Re: Snow thrower cab
Reply #24 Dec 24, 2008 11:43 pm |
|
The cab seldom has to have the window cleared off because the machine's vibrations pretty much shakes everything off. If snow does manage to stick to the window, a tap from the inside takes care of that. Believe me, it's a much better experience clearing the driveway on a windy day inside a well built snow cab. You got me thinking, I wonder if Armor-All would make that vinyl slick enough that the snow would fall off by itself? or Rain-X? I think you guys have convinced me to get one of these. The wind always seems to blow in opposite directions at the top and bottom of my driveway - about 100' separated by heavy woods. I always wear a cowboy hat when blowing as I can tilt my head and the large brim will catch it before it gets on my glasses, but I'm not always fast enough.
This message was modified Dec 24, 2008 by Bill_H
Who the hell let all the morning people run things?
|
don1
"If you search for a perfect friend without faults . . . you will remain friendless"
Location: Southern Ontario, Canada
Joined: Oct 21, 2008
Points: 6
|
|
Re: Snow thrower cab
Reply #26 Dec 25, 2008 7:42 pm |
|
Hi Clay: I'am running an Ariens 927LE and purchased an Ariens Sno Cab for it (paid a premium price) and look upon it as one of the best investments I ever made. When in use, it's like using the Snow Blower in the garage. No wind, no snow all over you and seems like 15 degrees warmer than outside. As far as removal of the cab goes, it's not worth taking the time to do. I will take it apart in Spring for Summer storage and also make it easier to do my maintenace work if any. Then come Fall, back it goes and gets attached to the machine. There are some aftermarket Cabs out there and they are probably OK, but I love my orange Ariens Cab with the heavy duty material. So the short answer is: Yes, a Snow Cab is definitely work investing in.
|
|
|