Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I've got a flat driveway that's approx 75' in length. Do I really need the automnatic traction control on the 924DLE or is the Fingerttip Remote Lock/Unlokck on the 927LE adequate? How about for a woman to operate? Manay thanks!

The trigger on the Simplicity releases one wheel only.  It's incredible how easily the machine (any machine) will turn with just one wheel engaged.  I had two old Craftsman machines that had the pins on the wheels.  They were both kept perpetually in two wheel drive for the entire time I owned them.   It was a wrestling match for twenty years.  Still a lot easier than shoveling tons upon tons of snow.  If you find the machine you have a bit too much to handle, you should seriously look at getting something with a trigger release.  Now that I have one with it, I'm spoiled.   As well equipped as the Simplicity is, this has to be one of it's best features.   

steelers wrote:

I was wondering how the Ariens 927LE "Fingertip Remote Lock/Unlock" feature worked.  Their brochures and web site say nothing, and it's hard to find the information elsewhere short of coming to a forum. 

Anyway, I stopped by Home Depot a few days ago and saw that they just received a new shipment of the 927LE, so I took a look at the manual hanging in the plastic bag.  I took a cell phone photo of the part about the "Fingertip Remote Lock/Unlock".  Here's the direct quote from the blower's manual:

     "Squeeze and release the remote wheel lock control to lock the left wheel for better
     traction when throwing snow or to unlock the left wheel for easier steering.
     NOTE:  The wheel lock will not release when under load.  Do not unlock the wheel 
     while turning.  If the wheel lock will not release, turn the unit slightly left or right to
     relieve axle load and release the axle lock.
     If remote wheel lock does not lock or unlock properly, adjust or repair before
     operation."

That's it.  It seems like you have to stop the blower's motion before using the lever.  So you get dual-wheel operation when moving, but after you stop and squeeze the lever, you have independent wheel movement to re-position the blower.  Then you squeeze the lever again to re-engage dual-wheel operation.  At least that's my interpretation.  Whatever, it's better than being stuck with nothing but dual-wheel motion even when you are trying to re-position the blower.  I've done that with the low-end Husqvarna at work, and must say that it is a real pain and not at all convenient.

borat wrote:
Borat, I've been wondering about your Simplicity.  As you keep moving along forward, can you squeeze your trigger and instantly go into the one-wheel operation (unlike the Ariens 927LE, where you apparently have to stop before squeezing the lever to re-position the blower, then squeeze again to re-engage both wheels to move again--info is from their manual)?  If you CAN keep moving while using the trigger, then I assume left-turning is fairly simple, but is it difficult to keep it going straight with only one wheel, and then what about turning right?  Wouldn't that be sort of hard with the right wheel going full speed?

coasteray wrote:

The wheel release mechanism is a cogged coupler.  When engaged, the cogs are coupled together.  Like splaying your fingers on each hand then putting your fingers together, end to end.  While under load, it is difficult to disengage the cogs.  Therefore, it is not recommended to release/engage the wheel while under load.  The strain on the cable will cause problems sooner or later.  I have however done it although not purposely.  It will disengage under load but reluctantly.  The best method is to stop the machine, disengage/engage the wheel and continue with the job.