have a 10 h.p. tec vert. shaft motor for a 30" rider tvxl220 157246b ser.20764,eletric start. Broken fiber governer gear. took another gear off of a ventilated motor. Couldn't find any numbers on the shroud at all.
Just has formula xlic 10 h.p. tecumseh,this is a pull start. Everything looked the same,put gear on and can't get the sump to go any closer than 1/4" to 3/8" to the block. The little ball shaped piece that is on an eccentric gear,starts going in place. The pins are also lined up. Where does the governer shaft, (the "L" shaped) piece go? does it ride inside,so that it lifts the gear up? (Motor is sitting on the fly wheel) Or does it just ride on the bottom of the gear? Then when the motor is right side up the L shaped piece lifts the gear so the weights fly out.
Motor ran great until this happened.
Thanks for the help
T.J.
Put it where the Big iron wheel runs!!!
