Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > b & S Passing oil though carb ???

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
mark044


Joined: Jan 27, 2008
Points: 18

b & S Passing oil though carb ???
Original Message   Aug 8, 2008 4:30 pm
Hi I think i got a big proplem I have a briggs & stratton 14.5 hp Intek with ohv. Model #285777.. type 1142-e1.... it for my lawn tractor....

    I started up my machine today and there was like little white/gray  smoke coming from my muffler  when i put the blades on there was a lot of smoke coming out of the muffer I stop it to check it out and I notice oil driping from my air filter I open up the air filter and notice it was full of oil..... can anyone help  ,,I'm thinking maybe the oil ring ????    thks Mark

Replies: 1 - 3 of 3View as Outline
niper99


Location: London Ont
Joined: Dec 2, 2007
Points: 354

Re: b & S Passing oil though carb ???
Reply #1   Aug 10, 2008 1:13 am
stupid question but is the oil level correct?

if the piston rings are worn u may have excessive blow buy which could cause oil in the air filter, u could remove the breather hose going from the valve cover to the air filter housing and run the engine and see if there smoke coming out of the breather hose if so just keep it disconected so it doesn't saturate your air filter, the oil could also be leaking past the valves into the cylinder l'm not sure if they use seals on the valves or not if they do u could replace them.

borat


Joined: Nov 10, 2007
Points: 2692

Re: b & S Passing oil though carb ???
Reply #2   Aug 11, 2008 8:04 pm
Sounds like too much oil in the crank case.  Most small engines have a crank case ventilation line that runs to the air intake side of the carburetor.  The theory is that vapour from the crank case will be sucked into the carb and burned off with the fuel.  I have a 6 h.p. Mitsubishi powered pressure washer that gave me a similar problem that you have.  The manual specified the wrong amount of oil to put in the crank case.  As it was, it was over filled.  Oil was constantly being blown into the carb intake.  Sometimes, it would make starting the engine difficult due to so much oil accumulating in the air filter.  I recommend you drain the oil and re-fill to the correct level.  Otherwise, you'll continue to have oil being blown into your carb intake until the oil level achieves the correct volume.    
friiy


Location: Las Vegas, The Desert
Joined: Apr 12, 2008
Points: 600

Re: b & S Passing oil though carb ???
Reply #3   Aug 13, 2008 10:55 am
Has anyone had this mower tipped on its side ?   Maybe to clean under the deck or to sharpen the blade.  This will also fill the breather and filter with oil.

Good luck,

Friiy

Replies: 1 - 3 of 3View as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.