Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Briggs/Stratton carb. mounted on gas tank type. After taking the primer bulb off or out,  I noticed this check ball inbedded in the outer channel of the body. Is this ball supposed to move freely or is it permanent.  The check ball in the middle is ok and I cleaned & blew out the rest of the carb. Also new diaphram. Any suggestions out there....

Things to check for:

1. Frayed or split tube going from bulb to carburetor, alchold in the gas is causing the rubber to stiffen a split faster than it used to;
2. The tube and orfices are clear;
3. There is gas in the tank and carburetor ( yes I've tried priming an engine with a dry tank, takes forever to get it going );
4. Bulb isn't split and/or leaking;
   

Excuse my retarded question, I have not had one of the new primer /diaphram Briggs carbs apart....

Does this carb have 2 fuel pick-up tubes in the tank?

Does this tank have the Second chamber right below the carb like the older vaccum diaphram auto choke models with the choke control rod mounted on the diaphram?

IF so,  I have seen the second chamber have a puddle of water in it and keep the engine from starting.. (unable to pull through the shorter pickup tube to the carb body)

Hey, do me a favor and post the model, type and code..   So I can give it a good eyeball.

Thanks'

Friiy

friiy wrote:

Does this carb have 2 fuel pick-up tubes in the tank?  (yes)

Does this tank have the Second chamber right below the carb like the older vaccum diaphram auto choke models with the choke control rod mounted on the diaphram? (yes)

and they do still use check valve ball style in some carbs.