Abby's Guide to Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more)
Username Password
Discussions Reviews More Guides
Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Toro Model 20005 Mower starts after priming but will not run

Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Search For:
arun


Joined: May 11, 2008
Points: 2

Toro Model 20005 Mower starts after priming but will not run
Original Message   May 11, 2008 11:01 am
I have a Toro Model 20005 with a Tecumseh engine.  It only start after pumping the primer about 5 times.  Then stops after the after a very short run, like no more gas is getting to the carbureator.  It does not have a fuel filter, the fuel line is not clogged. New Air filter, spark plug, and fresh oil. I have also cleaned out the carbureator with STP Carbureator cleaner.  Any suggestions? Thanks for your help
Replies: 2 - 2 of 2Next page of topicsPreviousAllView as Outline
friiy


Location: Las Vegas, The Desert
Joined: Apr 12, 2008
Points: 600

Re: Toro Model 20005 Mower starts after priming but will not run
Reply #2   May 12, 2008 3:42 pm
You must still have something in the carb.  I beleive that the carb bowl bolt on that modle is also the main jet.  Try taking off the bolt / jet and draining the bowl look for water or garbage.  There should be a hole on the shaft drilled straight through,  there should also be a metered hole drilled from the center of the threaded end to make a "T" of the holes, all those passages must be cleared.

Try this, good luck.

Friiy

Replies: 2 - 2 of 2Next page of topicsPreviousAllView as Outline
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Guide   •   Discussions  Reviews  
AbbysGuide.com   About Us   Terms of Use   Privacy Policy   Contact Us
Copyright 1998-2024 AbbysGuide.com. All rights reserved.