Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
onemangang
Joined: Jan 23, 2008
Points: 5
![]()
|
 |
toro 824
Original Message Jan 23, 2008 4:33 pm |
|
My toro's wheels have locked up, Everything engages correctly but the gears won't turn. Any ideas? Thanks in advance
|
donjag
i've gone to find myself,if i'm here when you arrive,keep me here until i get back.
Location: menasha,wisconsin
Joined: Apr 25, 2007
Points: 142
![]()
|
 |
Re: toro 824
Reply #3 Jan 23, 2008 5:09 pm |
|
with the machine tipped on to the auger,there is 4 bolts to take off,you will see the friction wheel,your tires are connected to a axle,on that axle should be a shear pin,either left or right hand side,if you see a hole and no bolt ,thats your problem,just fixed one yesterday.hope this helps you out.
|
onemangang
Joined: Jan 23, 2008
Points: 5
![]()
|
|
|
Re: toro 824
Reply #4 Jan 23, 2008 5:17 pm |
|
with the machine tipped on to the auger,there is 4 bolts to take off,you will see the friction wheel,your tires are connected to a axle,on that axle should be a shear pin,either left or right hand side,if you see a hole and no bolt ,thats your problem,just fixed one yesterday.hope this helps you out. I'll check that out, thank you very much!!
|
onemangang
Joined: Jan 23, 2008
Points: 5
![]()
|
|
|
Re: toro 824
Reply #5 Jan 24, 2008 11:09 am |
|
with the machine tipped on to the auger,there is 4 bolts to take off,you will see the friction wheel,your tires are connected to a axle,on that axle should be a shear pin,either left or right hand side,if you see a hole and no bolt ,thats your problem,just fixed one yesterday.hope this helps you out. Great description but that was not the problem. Thanks again.(any other ideas?)
|
mml4
Snow is good,
Deep snow is better!
Joined: Dec 31, 2003
Points: 544
![]()
|
|
|
Re: toro 824
Reply #6 Jan 24, 2008 1:16 pm |
|
Check the following- 1) return spring on the friction disk drive assembly. I am not familiar with the Toro but most machines move their drive wheels by engaging a rubber friction disk against a drive disk. When you release the handle control on my machine a return spring lifts the friction disk off the drive disk. If the return spring broke or became disconnected the machine would stay in gear and "lock" the wheels. If thats not it ,can you move the wheels by hand if they are off the ground or are they locked up? Marc
This message was modified Jan 24, 2008 by mml4
SnapperV210P,Toro22177,TroyBilt42010Snowthrower,Craftsman Shredder,American Turbo Pressure Washer HondaGX200,Stihl011Saw,EchoPas260Trimmer Edger,EchoPB602Blower,EchoHCR150Hedge Clipper
|
onemangang
Joined: Jan 23, 2008
Points: 5
![]()
|
|
|
Re: toro 824
Reply #7 Jan 24, 2008 2:06 pm |
|
It was the spring. Thanks a lot Marc and Don
|
|
|
