Abby’s Guide > Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) > Discussions > Snow Blower light install.
Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions |
|
snowking
Joined: Jan 13, 2008
Points: 2
|
 |
Snow Blower light install.
Original Message Jan 14, 2008 8:08 am |
|
I just acquired an older model craftsman snow blower . It has a 8hp tecumseh 25 inch clear and the trac drive. It would be nice to install a light to it. I checked for any extra power leads. None found. It is 80 h series motor. I checked a online service manual but I cannot determine if it has any extra power generation. I does have the 110v electric start. Any thoughts? Thanks
This message was modified Jan 14, 2008 by snowking
|
snowking
Joined: Jan 13, 2008
Points: 2
|
 |
Re: Snow Blower light install.
Reply #3 Jan 14, 2008 9:10 am |
|
I recall the previous owner saying there was a light kit available. I know there is some wiring under the shroud were the throttle is located. When you drop the throttle down it shuts off the engine. I was going to place a meter on it and see if there is power there. I will check under the shroud where the starter is to see if thereis a cable hiding there. Thanks
|
|
|