Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Just bought a Toro 6.5 HP CCR3650 and I'm having problems starting it.  Followed all directions but lots of blue smoke being emitted when it does start.  Doesn't seem to have enough power when egaging auger and dies almost immediately.  Mixed 6.4 oz Stihl oil with 2 gallons gas.  Seems like it should be easier to start and use...any help would be appreciated.  Thanks. 

Hi Guys!

Trescher-

I think you will find the mix should be 2.6oz./gallon. At 6.4 for 2 gallons you are way too oily. I'm thinking the excess oil is fouling your plug. Drain your fuel tank,replace the spark plug which is probably fouled and start with fresh mixed fuel at 2.6 OZ./gallon. My local ope dealer also says to use high test in 2 strokes. I have been following his directions as to high test and have had no problems with any of my 2 stroke equiptment.  

 Also make sure the choke lever is in the run position and that the choke plate it controls is connected to the lever. Once in a great while the linkage on the choke may be disconnected and the engine remains choked regardless of the lever position. This is a rare occurence.

I'm thinking it's the fuel mix,

Marc 

  tip unit onto the discharge chute.  remove the two  5/16 screws on either sode holdong back cover on.   remove cover you will see all the goodies.   if its a plastic carb,  still toro's design,  loosen the four phillip head screws.  the extra oil will run out that is sitting in the bottom of bowl.  if its a metal carb,  briggs and stratton own this engine now and have made some changes to it.  crack loose the bottom bowl nut and so the same.

     we use opti-2  here in the shop.  you can buy a 1 gallon mix pouch or 2 gallon mix pouch.    with this mix it will run all equipment regardless of mix ratios.   16:1   to  100:1  .   stuff is great.