Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Sears had a recall last summer-fall to fix these machines because of a concern about fire when primed.  They offered an oil change, new spark plug along with the new fix. 

The technician arrived at 9 am on a September day and acted very nervous and shaky when he worked on the machine.  I asked him if he was ok and he responded that he had too many recall type service calls and not enough time in the day.  He kept rushing and scattered screws and parts all over the place.  I gave him a plastic container to hold the parts while he worked.  When he put it all back together and was ready to leave, I asked him to start the machine for a test run.  He ran it for thirty seconds or so, shut it down and I assumed it was ok.  I should have test run it again in November but took it for granted that all was ok. 

I have only used this machine ONCE.  It was last February 2007.  Purchased in February 2006, it sat for a year unused in a snowless winter.  I have a feeling the troubled technician's bad day is now haunting me.  Sears can only send a tech out on January 2, 2008 so I'm stuck with a machine sitting out half the winter.  (I did have the urge not to have Sears do this fix but they were fairly aggressive with mailings, etc.)  The machine is also under the extended warranty I purchased. 

Anyone else out there who had Sears call on them for this so-called fix?

I tried the pull start first with choke on full (primed with two shots as required).  After waiting several minutes, I then tried the electric start after I walked through the owner's manual check list with everything in place and it still won't start!  I returned 30 minutes later to try again and still no start.

Good news!

The "good tech" arrived this morning and used ether to start the machine.  He let it run for a minute or so, shut it down and restarted it in a normal fashion.  He then let it sit for five or so minutes, restarted it and let it run for a few minutes.  At my request, he approached an old snow pile to test it with a load, cautiously because the snow had transformed into a hard pile with some powder underneath.

After shutting it down for a moment, I started it on the first pull while he observed.  He (we) never did figure out why it wouldn't start for me shortly after his last visit.  It's now running beautifully and sounds great, nice and loud.  I wear a headset to supress the noise.  He then reattached the "cab" brackets which were removed previously (and unnecessarily) by the other tech.

Borat, I mentioned your comments about this B & S engine series and how the horsepower variables go up to 13hp.  He agreed, and said that it's a mighty powerful engine for snow blowing.  Your shared knowledge on these forums is much appreciated and highly valued by all of us.  We're all lucky to have such a knowlegeable, articulate and highly experienced snowblower specialist with small engine expertise and who just happens to live in a snowy area of Canada; and is SO willing to help!

Thanks again!

Snowbound, You have more patience than I.  sept to late jan is a long time especially when the item is seasonal.

Good Luck.

(BTW/ I wear hearing plugs and hearing muffs. I feel much less fatigued when wearing them than not wearing them.  Big difference.)

Thank you very much for the compliments Snowbound.

There are several valuable members participating in this forum who contribute a great deal of knowledge and experience.  I find that it's the maturity and sharing of useful information that separate this forum from the others.  It's of no value to me to read about why "my machine is better than your machine" or brand advertising in general.  The people who use this forum have genuine issues and are often in need of guidance.  The quality of information provided here impresses me.   Lots of common sense and real life experience to draw from.  I enjoy helping others and appreciate the numerous gems of knowledge offered by others that I had not previously known.  It's a good place. 

It hasn't snowed here for almost two weeks and it's been dangerously cold.  The last week or so the temps have been pretty steady at 20 below F.  With the wind chill it's been between 35 and 45 below.   Too cold to do much outside.         

Thought I would add an informational follow-up especially for those who own Sears snowthrowers in the Northeastern U.S.

Yesterday, I received another automated survey call from Sears with the usual five questions.  Press one for poor and five for exceptional.  The first four questions were about the good technician and I gave him all fives.  The final question asked how I would rate Sears service and I pressed one.  Approximately two hours later (coincidence?), I received a call from a Sears representative who asked about my service experience.  She then told me they would extend my home service repair warranty for an extra year.  A warranty which is pretty comprehensive in itself.  This is the original warranty I purchased for a three year duration.  I now have it up to Feb. 2010.

I was dissapointed when I heard their reason for the extension.  She said Sears took too long  -  over two weeks  =  to respond to my first request for a service call.  I called them on December 13th and they arrived for their first attempt-to-fix on January 2.  I believe she said, if it takes over two weeks Sears will offer some kind of ("compensation", my word).  The ongoing soap opera episode which included the bad tech and which began on Dec. 13 and ended on Friday, Jan. 25 apparently did not have any impact on their decision to offer this extension.  If the extension offer was all about a slow response, why did it take so long to call with the offer?  I didn't question them on this. 

She added that Sears has a shortage of snow thrower technicians in the Northeast, especially in the Boston area, and they are offering their customers the benefit of a warranty extension.  Sounds like a committee decision.  I'll take it. . . for now.

Today I ran the machine and it was music for me.  Full choke, started on the first pull, ran it for ten minutes and shut it down.  Started again (no choke, of course), ran it for another ten minutes and shut it down.  Temperature was at 34F. 

As a follow-up to my recent soap opera drama with Sears, I started my machine today (to excercise it) with three squirts of primer and only two pulls.  Blamm!!  Sounded great!  Air temperature was 30F on a clear day.  My hope for this snow thrower is that it's a Briggs & Stratton.

Ran it for twenty minutes at recommended full power, reduced the throttle to fast idle in the final minute and then shut it down.  Nice.

Here's a brief update from last season's drama with Sears Service and my new machine.  All is well.  Starts on the first pull, runs extremely well and is very powerful!  We got eight inches today in Massachusetts, blowing snow (powder), temp nine degrees and winds gusting to 35 kts.