Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

THE MOVIE

You may leave your comments and apreciation on youtube if you wish!

Loose tolerances.

 A gap of 3/8ths between impeller and impeller housing is cheaper to make than one with less than 1/64th!!

Think of you blower as a water pump, how well does a "water pump" pump with a large gap between housing and impeller, worthless!!

                                                       Fred

that was great,i really liked the sound effects of the snow bouncing off your vehicle,was it easy to install?i want one.

donjag wrote:
I think 2 hours is the average time for installing the kit. The hardest part is to tighten the bolts in the back of the impeller.

how come?tight space?

donjag wrote:
on Ariens there's a 90 degrees angle steel plate in the back of each blades and thats where its hard to tighten

i was just wondering,it looks like it works great.i have a monster john deere that hate wet slushy snow,if i didnt get it free,i would blow it up.but it eats powder like you would not believe,thanks.

Good going Denis.  You can really hear the engine bark when you get into the slush stuff.  Obviously nasty stuff to move.  The machine really blasts that stuff out.  Wouldn't want to be caught in front of it. 

By the way, thanks for the advice and posting my picture.  When I tried to add the attachment, I didn't have any choices.  I just displayed the image then copied the address for it from the top of the page.  I didn't see anywhere else that would give me an alternative.  Any suggestions?

Click on the yellow window thumbs up here that shows little mountain then paste your URL and your done

Hi Denis.

Thanks for the info but I had that part figured out.  My problem is trying to find the correct URL with the .jpg file over at www.serving.com.  When I select this picture, this is the only detectable URL  and it's right up at the top of the page in the address field:  http://www.servimg.com/image_preview.php?i=3&u=11783895

So, my problem is trying to get the correct address for the picture.  Any suggestions there?

Thanks for the help bud.  

check completly down the page of serving ypou'll find it Adresse de l'image