Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hi all there it is finally, my ariens has been restore all over. It took me 40 hours of labor to put my Ariens back in shape. I got this blower for 125$ last Feb, and notice it was in bad shape. I put on a new auger belt, auger bushing, shear bolts and nuts, new sticker ST824( original sticker comes with the steel plate discontinuated). Carburator was clogged and unajusted, I have to dismantle auger assembly, one of the shear bolts was broken and the rake was stock in  rust. I had to cut it to get it off. Gear case was OK but change the gasket and liquid grease. Recoil starter rope wasnt,there, one of the muffler bolts was stripped, eye bolt that hold the chute rod was broken too. I still got the wheel chains but I dont know if I am going to put them back on, I may thinking to get new hogs will see!

here's some picture

BEFORE

at left is my very old viking 1 stage built by MTD Products in the early 1970's. The MTD model is 325-470-514 (Viking 6743).  

AFTER

More_Power wrote:

Yes I stripped the surface to the steel with this fantastic tool from

Then applied 2 coats of rust killer primer from rustcheck product (thin coats for best result)

And finally duplicolor engine enamel (in my case D1620 for Ariens)

For extra strengh, you may use Auto Spray® Clear Top Coat DS125