Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I have 1984 Snapper 8241. It runs great but need to replace the auger belt and brake pad. It looks like a big job as it appears you have to take the entire blower housing and augers off. Any idea what a shop in twin cities area would charge to do this(and a recommended place to go)?

You don't have to remove the augers to replace the belt.

The basic process is:

1. Pull ignition key and remove spark plug;
2. Remove pulley cowling at front of engine.
3. Loosen the bolt holding the idler wheel and move it to its "wide open" position;
4. Use a large screwdriver and leaver off the auger belt from the pulley while slowly turning the engine over by pulling the manual start;
5. Use a ratchet tie down and tie one end to the handle bar and hook the other on the top of the auger housing, tighten;
6. Undo the two big bolts near the top of the chassis that hold the front half together with the back half. The two halves will want to pivot open, thats why we have the tie down.
7. Loosen the tie down and let the two halves open up  a bit.
8. Remove the auger belt from the big lower pulley;
9. Install the new belt on the big pulley;
10. Use something to pinch the top part of the belt together ( twist tie, elastic band, cardboard sleave the belt came in);
11. Use the ratchet to pull the two halves together making sure the belt doesn't get tangled - thats what pinching the top together helps do;
12. Reinstall the two big bolts, use lock washers;
13. Remove the tie down;
14. Release the top of the belt;
15. Use the large screwdriver and the manual start to reinstall the belt on the top pulley;
16. Adjust the idler wheel so the belt slips when the auger control is disengaged but doesn't when the control is engaged;
    
17. Reinstall the cowling;
18. Attach spark plug, put in ignition key, start her up and go blow snow.
    

I've never replaced the brake pad so I can't help you there but it looks like its riveted to the pivot arm that the auger idler pulley is mounted on.

  i would try  FRATTALLONES ACE HARDWARE   hint

Thanks all and especially Nibbler. Looks like a nice July day project when cold beer can assist the process.

I'd drink the beer to celebrate the successful completion of the project not during, power tools and alchol make for a bad mix.