Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I am new to this board, but it seems like the kind of place I can get straight answers.

I have an older Ariens ST1136. The muffler was threaded directly into the block and those threads wore out. I purchased an adapter from B&S that bolted into the block and then the muffler screwed on to the coupler (with a female/female coupler). My issue is the bolts keep working loose and the muffler falls off. I have tried thread locker, but that did not seem to help. The muffler sits about 10 inches from the block (8 inches of muffler, coupler and adapter).

My questions are:
1. Is there another way to lock the threads? I was thinking JB weld
2. Is there another muffler combination that works better?
3. Is there a way to brace the muffler to lessen the troque?

Details (if these help)
Engine:
Briggs and Stratton 11hp
Model 252416
Type0632-01
Code 85092410
Muffler B&S part # 391569S
Adapter B&S pert # 392700

Bingo!

Sounds like a job for lock washers.

If I'm picturing this properly you have bolt holes in the engine block. You use bolts to attach the adapter to the engine and then screw the muffler into the adapter. The muffler doesn't come loose but the bolts do.

If you have stripped the threads in the block then you would have to either bore it out and retap it or bore it out and put in an threaded insert. I'm hoping that the lock washer solution will work.