Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I recently aquired a Snapper i 422, it has a 4hp Tecumseh engine. The model number on the snowbloer is i4222e if that would help any. My question is about the carb. When I put gas in the tank and turn on the shut-off, gas starts coming out of a pinsize hole in the side of the carb (see picture).  When I push the primer gas shoots out of the hole. I'm pretty sure this isn't supposed to happen. any suggestions on why it is? I looked in a small engine repair book and a carb that was like mine had a discharge hole, but I'm not sure if thats what the hole on mine is. Also, can anyone think of any way to get this fixed? The pictures are kind of blury, but my camera doesnt work very well that close up. By the way, the only information i could find on the engine is that its hs40 you can google it if it helps.

     

Launboy,

5552L is the engine Spec, 555 says it's a HSK40 engine, other long  number is it's serial number.

Hope this helps!!

                                         Fred

Fred, thanks, I kind of thought that the one after the SER was the serial number, but my thoughts have now been confirmed.

'Lint, I sent you the e-mail hope you got it.

Last night Took off the bowl, and the float was indeed stuck.  Cleaned that out and put it back together, and guess what.  No more gas out the vent hole!!  I'm going to have to get a new seal for the bowl, becuase the one on there now it old and falling apart.  When I pushed the primer though gas came out of somewhere on the back of the carb, didn't invetigate last night though, to cold, and my hands were getting numb.

Adam

Went to my favorite little OPE shop today, and got the primer for the Toro CCR 1000.

I also ordered a carb rebuild kit for the Snapper.  Should be here sometime early next week.

Adam