Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Hi i have an tecumseh 6 hp motor and this year i took it out to mow my lawn and i got it about half done  ant the mower cut out i thought it might have been out of gas but the gas was fine.
i knowsed that it would only go while continue ous pushing of the primer bulb or just holding it in.So where i my self am a pretty good handy man i removed the carb to check it anc clean it during the removal process the i nodiced the air filter had a hole in it and might have sucked in some dirt and clogged up the carb. Once i cleaned the carb i put it back on and i tried to start it but would only run for a few seconds and cut out but if i hold in the primer bulb the mower and it runs fine.

Hi thanks for the tip i checked the bowl it is in the right spot according to what you said any other ideas?

    Lucas

check your lines to and from the primer.....a crack or air leak here would allow it  to suck air and create a vacuum leak, or possibly the diaphram in the primer bulb has gone south. try replacing the primer bulb and while your doing that go ahead and replace the primer bulb lines

i had the exact same problem on a leaf blower and what i mentioned above turned out to be the problem