Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

I bought a discharge chute on eBay that was new and had the part number 52411300 written on it.

What model # Ariens does this fit?  I was told it went on a 932 series machine but looked through Parts Radar and didn't find it. It's roughly 28 or 29" long measured along the back arc from bottom to top.

My chute has the same 2 holes located at the same angle with the distance between them being 3 1/8 " The bottom of my chute is almost 6 inches at the widest point of the flange. The curvature of my chute looks about the same as yours.

 Maybe your machine has different snow throwing characteristics and does not need a blow-by kit. BTW, the blow-by kit flange is 16 inches long and is designed for the right side of the chute from an operators perspective. The right side only had the blow-by problem when the chute was cranked fully to the right. The snow used to pile up on my battery tray.

The newer chutes have a couple of  inches added to the flange width.

Hi Garandman:

You replied to an earlier post I made about a 79 vintage ariens 824... could you please tell me what Briggs OHV engine you put on yours?  Does it make an exact fit?

           My model is 924050  sn: 019151

Sorry for the OT post, but your email is blocked and this seemed the only way to contact you... if you'd prefer to email use: jhart3 at hotmail dot com ...

thanks

What thread? You can still PM.