Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

New here and I thank you all for all your input.
I have a Noma/Murray snowthrower. I service it well and it still runs trouble free.
When I grease the zerk fitting under the disk drive plate, I always have a hard time "turning " disc drive plate by hand to access the zerk fitting.
It doesn't seem to turn by hand and I end up starting the machine, using the controls, then looking under the machine to see if the zerk is exposed.
Any ideas in what I'm doing wrong here ?   Happy Holidays  !
Mike

What if you were to remove the spark plug and turn over the engine with the starter rope while holding down the appropriate control handle. Would this bring the zerk to the proper place?

Whups - I just reread my post and I think you want to turn the wheels with the traction system dis-engaged. If its engaged you're trying to turn the engine over.

No problem, I think I'm getting the idea that it works from the  wheels. I 'll try the suggestions and see what works.
I think I engaged the drive system and turned the wheels by hand.  I didn't remember this year, the next time I have it up, I'll try again.
Thank you all again.

Mike