Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Guys

Today I had a problem running the auger on my Ariens 7524 that I just got a couple weeks ago. I started it up and the first time I ran the auger the engine died. I restarted it and when I ran the auger this time it kind of screamed and I immediately shut off the engine. Both times the auger was not under load and the machine was stationary.

I pulled the spark plug, used the shovel to clear as much snow from the shovel housing and impeller area as I could, then banged it up and down a few times. The auger ran with no complaint this time. I'm still not sure what the problem was other than there was quite a bit of impacted snow inside the shovel housing and after I cleaned that it ran fine. Would the shaft or the impeller itself have been frozen?

When anyone encounters an unmoveable auger what do you do? I don't have the option to move it into a warm area. Is it safe to throw warm water into the impeller area or are you just compounding the problem? I have been running the impeller for 20 or 30 seconds before shutdown but today I followed the letter of the law and ran the auger for almost 3 minites. I also cleaned as much snow out of there as possible before I stored it. Is this an effective preventative for a frozen/stuck auger/impeller? I'm hoping this isn't a common problem for Ariens and/or the Ariens compact series. Thanks for any advice.

nibbler

can you explain where exactly you put the 2x4 to stop it up? Also, what do you use to clear a jam? I saw something on the internet today, a really cool orange stick shovel expressly for the purpose of jam clearing, but it looks like it isn't sold in Canada. The little Ariens shovel is OK but I would like something longer when I have to clear down into the chute. Thanks.

nibbler, sorry forgot to ask, when you say spin, do you mean the bit of looseness in the auger blades that you can see are loose on the main shaft or spinning the impeller? I have tried with the shovel to get a little movement out of the impeller but it seems to be quite immovable when everything is shut down.

I put the 2x4 in down the chute into the impeller. To see if there is any tension in the system I'll try to turn the impeller with the 2x4.

I just use a stick or old broom handle. You can also get a fairly robust kids shovel and cut it down a bit if need be. The big thing is to make it so that it is carried on the machine and is convenient to use.