Outdoor Power Equipment (Lawn Mowers, Snow Blowers, Chain Saws and more) Discussions

Five years ago when I bought a new lawn tractor, I was so overjoyed at having something I could depend on that I fell into a bad habit. It was new, so I didn't pay much attention to it. Since joining this forum, I've tried to make up for my errors. The other day I was cleaning-checking-lubing and it dawned on me that I'd never greased the zerks on it. Since it only has about 300 or so total hours I wasn't too worried...but I asked my neighbor to do it (since I didn't have a grease gun). I figured only a couple squirts on each fitting were needed....WRONG!!!  The front axle alone took more than two 14 ounce tubes of Lubriplate, and the fittings on the front wheels each took several squirts. I have seen the LIGHT!!!, and now have my own grease gun. I think these are the only four fittings on the machine (it's just a simple AYP with a 14.5 vertical opposed Briggs, 42 cut). It's had one mower belt replaced, also the steering drag link (probably due to lack of lube). Am still in a learning mode.

AZ  

The Andersons (Nasdaq: ANDE) has grown quite a bit from it's beginnings as a farm supply company. If interested, the corporate site is  www.andersonsinc.com and the retail store site is www.andersonsstore.com  I don't really know if the family is still involved, but I suspect it is. Also, there is www.andersonmowercenter.com , where I purchased my Toro 726.

AZ

   ABOUT THE ANDERSONS...


OFFICERS AND DIRECTORS

Dennis J. Addis President, Plant Nutrient Division Daniel  T. Anderson President, Retail Group Michael  J. Anderson President and Chief Executive Officer Richard  M. Anderson President, Processing Group Richard  P Anderson Chairman of the Board of Directors Thomas  H. Anderson Chairman Emeritus, Board of Directors

Looking at a partial listing of Chiefs, I'd say the family is still involved........